Novatec Glass – General
Cleaning & Handling Guidelines

This General Cleaning & Glass Handling guide provides general advice for the safe cleaning, handling, and storage of Novatec Glass products. For specific applications or concerns, we recommend consulting a qualified glazier or professional window cleaner.

Routine Cleaning

To maintain the clarity and appearance of Novatec glass surfaces, regular cleaning is recommended using non-abrasive, glass-safe products.

Recommended Cleaning Solutions

  • Commercial glass cleaners such as Windex®

  • A homemade solution of 1 part white vinegar to 10 parts water

Cleaning Procedure

  • Generously apply the cleaning solution to the glass surface using a spray bottle or a clean, saturated cloth.

  • Gently scrub the surface with a lint-free cloth or towel.

  • Dry the glass using a separate clean, dry lint-free cloth.

  • For a streak-free finish, stop wiping when the surface is nearly dry and allow the remaining film to evaporate naturally.

Specialty Glass Considerations

Glass with coatings (e.g., Low-E or reflective finishes) or textured surfaces (e.g., acid-etched glass) requires extra care. Avoid harsh chemicals and abrasive tools. For detailed instructions, refer to product-specific guidelines available from Novatec Glass.

What to Avoid

  • Do not clean glass in direct sunlight or when hot, as this may cause streaking or damage.

  • Avoid contact with glass edges, especially on laminated or insulated units.

  • Do not use acidic cleaners containing hydrofluoric or phosphoric acid.

  • Avoid abrasive materials, including scouring pads, powder based cleaners, or rough cloths.

  • Do not store materials against glass surfaces, which may cause scratches or thermal stress.

  • Avoid sudden temperature changes, such as applying hot water to cold glass.

  • Be cautious with adhesives or tapes, which may stain or damage the surface.

Storage & Handling

Proper storage and handling are essential to prevent damage during transport or installation.

Storage Guidelines:

  • Store glass vertically at a slight angle on padded supports.

  • Keep in a dry, well ventilated area, away from direct sunlight.

  • If glass arrives wet, separate and dry panels before restacking with spacers.

  • Use protective materials (e.g., paper, rubber pads, plastic wrap) between sheets during transport.

Handling Guidelines:

  • Only trained personnel should handle glass, following safe lifting and movement practices.

  • Ensure glass is securely fastened during transport to prevent breakage.

  • Protect glass from construction site contaminants such as cement, paint, or dust.

Installation Notes

  • Use neutral cure sealants for laminated glass to avoid damage to the interlayer.

  • For insulated glass units (IGUs), ensure sealants are compatible with the secondary seal.

  • Avoid installing glass near heat sources that may exceed 200°C, unless specifically approved by Novatec.

  • Follow AS 1288 standards for glazing and installation.

Disclaimer

  • This document is intended as a general guide only. Novatec Glass does not accept liability for damage resulting from improper cleaning, handling, or installation. For the most current version of this guideline or product-specific advice, please contact Novatec Glass directly.

What to Avoid

  • Do not clean glass in direct sunlight or when hot, as this may cause streaking or damage.

  • Avoid contact with glass edges, especially on laminated or insulated units.

  • Do not use acidic cleaners containing hydrofluoric or phosphoric acid.

  • Avoid abrasive materials, including scouring pads, powder based cleaners, or rough cloths.

  • Do not store materials against glass surfaces, which may cause scratches or thermal stress.

  • Avoid sudden temperature changes, such as applying hot water to cold glass.

  • Be cautious with adhesives or tapes, which may stain or damage the surface.